OPTIC-RUN PRODUCTS AND ACCESSORIES

OPTIC-RUN TRUNKING
The main conduit consists of a single injection-moulded piece.

OPTIC-RUN JONCTION
The Optic-Run T-piece and cross allow branches to be created to connect the main conduits and other components.

OPTIC-RUN ANGLE PIECES
Optic-Run angle pieces are used for the horizontal rerouting of optical cables..

OPTIC-RUN ELBOWS

Downward elbows are used to route optical cables downwards.

Upward elbows are used to route optical cables upwards.

OPTIC-RUN REDUCERS – ACCESSORIES
Reducers reduce the size of main conduits and other components and feature snap-on connectors.

OPTIC-RUN CURVED OUTLET
The curved outlet is the final protective component that guides the optical fibre cable to the protected area with a minimum bend radius (30 mm).

OPTIC-RUN END CAP
The end cap is used to seal the open ends of the main conduits and other components, and does not require a snap-on connector.

OPTIC-RUN CONNECTOR
The snap-on connector allows the connection of one cable raceway to another and is required when adding a deviation or an accessory. Locked using a standard Phillips screwdriver.

OPTIC-RUN SIDE MOUNTING BRACKET
The side mounting bracket is used to install a cable tray on a rack.

OPTIC-RUN ACCESSORIES
Accessories are also available to manage, protect and fasten optical fibre cable raceways.